T o r e m o v e t h e F r o n t P a n e l a n d t h e C o v e r
1
2
3
Figure 25 Laser head cover removal
4
5
Agilent 5517B/BL/C/D/DL/FL User's Guide
Remove ±15V power from the Laser Head.
Rotate the front- panel shutter (MP6) so that the large opening is at the
bottom and the slotted screw is visible through the opening.
Using a flat- blade screwdriver, push and rotate the screw 1/4- turn in
the counterclockwise direction as shown in
Remove the front panel by gently pulling it straight away from the laser
head.
If you have a single- piece cover (MP10), remove it by gently pulling
the cover forward and out. If you have a two- piece cover, not shown,
remove the covers by gently pulling forward and up. This releases the
edges of the cover(s) from the retaining grooves along the edges of the
rear panel (MP3) and the laser base.
When reinstalling the cover (MP10), ensure the cover edges are
properly engaged against the gasket material in the retaining groves of
the laser base and the rear panel (MP3).
Service
Figure
25.
7
69