Porsche 996 TT Repair Manual page 133

Remove the remaining quantity of oil from the oil filter housing by suction.
6. Clean oil drain plugs. Always replace the sealing rings. Make sure that the sealing ring on the oil
container is 2 mm thick. Tighten the drain plug on the crankcase to 70 Nm (52 ftlb.) those on the oil
container to 60 Nm (44 ftlb.), and the drain plugs on the turbocharger to 30 Nm (22 ftlb.). Counter with a
wrench when tightening the drain plug on the oil tank.
7. Tighten oil filter. To do this, use the special tool release key 9204 and tighten the oil filter cover to 25 Nm
(19 ftlb.).
Slowly pour 7.8 litres of engine oil into the oil container.
Note
• Fill in engine oil slowly in order to allow the oil sufficient time to flow from the oil container into the
crankcase.
8. Check the oil level. Check oil level on the instrument cluster and correct. Seven segments must be
displayed in the instrument cluster.
Note
This cannot be checked with the oil dipstick
•
• The vehicle must stand horizontally
• The engine must be idling during the check.
03 Changing the engine oil and oil filter
einordnung
70