Add IP Solutions
Connect the Ethernet
1. Connect the network cable to the ETHERNET connector on the TN802B
external cable assembly.
NOTE:
You need a CAT5 or better cable for 100-Mbyte operation.
Install the Circuit Pack
!
CAUTION:
When adding or replacing any hardware, be sure to ground yourself against
electrostatic discharge (ESD) by wearing a grounded wrist strap.
NOTE:
The TN802B IP Interface is hot-swappable, so you do not need to power
down the carrier to install it.
If you need to remove the TN802B IP Interface from the carrier at a later
time, shut down Windows NT first by pressing the recessed reset button on
the faceplate (see
until the LCD shows a flashing MSHUT *. When the flashing stops and the
asterisk disappears (about 2 min), it is safe to remove the circuit pack.
555-233-118
Figure 5-13 on page
5-80) of the TN802B IP Interface
Issue 5 October 2002
5-79