Avaya CMC1 Installation, Upgrades And Additions page 278

Adding or Removing Hardware
8
Figure Notes
1. Amphenol connector to connector
corresponding to TN802B slot
2. To VGA monitor
3. To USB (not used)
4. To keyboard
Figure 5-11. TN802B IP Interface External Cable Assembly
3. Read and follow any directions inserted into the package by the factory.
Connect the Cables
1. Determine into which port slot you are putting the TN802B IP Interface.
2. From the rear of the cabinet, connect the Amphenol connector on the
external cable assembly to the backplane connector corresponding to that
slot (the highest numbered connector of the 3 slots required).
Connect the Modem
NOTE:
These instructions are for connecting the U.S. Robotics modem supplied to
U.S. customers only. If using a different modem, follow the manufacturer's
instructions on connecting the modem.
1. Connect the RS232 port of the modem to the MODEM connector of the
TN802B external cable assembly.
5-76
Issue 5 October 2002
7 6
NOTE:
Make sure that at least 3 adjoining slots are free.
5 4 3
cbdfocto AWF 122398
5. To mouse
6. To ethernet
7. 25-pin male connector to modem
8. 25-pin male connector to COM2
1
2
555-233-118