Avaya CMC1 Installation, Upgrades And Additions page 90

Installing and Cabling the Cabinets
Install Attendant Console — Optional
To install a DCP attendant console:
1. Position the attendant console in the desired location and connect the
modular cord to the information outlet.
2. Install labels per the Attendant Console form and Display Module form
assignments.
3. Install a Digital Line circuit pack in the assigned carrier slot (if required).
4. Administer the Attendant Console forms in Administrator's Guide for Avaya
MultiVantage Software.
Hard-Wire Bridging
!
CAUTION:
Bridging or paralleling these endpoints can cause electrical damage to the
consoles or cause the circuit pack to remove power from the consoles.
Analog type hard-wire bridging is not allowed for 4-wire (only) DCP endpoints.
This is because hard-wire bridging provides no way of combining the digital output
of 2 bridged DCP sets. Also, a bridged endpoint causes the added load to
degrade the DCP signal.
Dual Wiring of 2-Wire and 4-Wire Endpoints
Do not simultaneously wire a 2-wire and 4-wire endpoint to the same equipment
location in an MDF, even though they connect to different colored wire pairs. The
system uses separate circuit packs to interface 2- and 4-wire endpoints, and none
are capable of interfacing both.
Install 26B1 Selector Console — Optional
1. Connect the supplied 3-foot (0.9 m) D8AC cable to the modular jack on the
bottom of the 26B1 Selector Console.
2. Route the cable to the attendant console and connect to the DXS/BLF jack.
3. Attach labels according to the Attendant Console form.
4. Administer the console using Administrator's Guide for Avaya MultiVantage
Software.
1-76
Issue 5 October 2002 555-233-118