Avaya CMC1 Installation, Upgrades And Additions page 238

Adding or Removing Hardware
LAN cable
The TN2501AP circuit pack does not include cables to connect the circuit pack to
your LAN. The following table lists the cable category and connection port.
Ethernet connection speed
10 Mbps
100 Mbps
Switch administration before hardware
installation
Before inserting the circuit pack into a carrier, an Avaya representative must
administer the VAL customer options. Before installing the hardware, check your
system for the following administration:
1. At the SAT, type display system-parameters customer-options and
press
The System Parameters Customer Options screen appears.
2. Verify that the G3 Version field is set to V11.
3. Verify that Maximum VAL Boards field is set to 1 or greater, up to the
maximum number allowed in the system.
4. Scroll to page 4.
5. Verify that the VAL Full 1-Hour Capacity? field is set for the offer that
was purchased:
If any of the preceding administration is different, you must get a License File with
these customer options enabled and install it on the switch before the TN2501AP
circuit pack works.
5-36
Issue 5 October 2002
Cable
Category 3
Category 5
.
RETURN
NOTE:
Any value greater than the default (1) means that you have the
Enhanced offer.
n for Standard offer (10 minutes storage time) and only 1 circuit
pack.
y for Enhanced offer (1 hour storage time) and multiple circuit
packs.
Connection description
Connects through the RJ45 jack
(note #2 in Figure 5-3),
Connects through the RJ45 jack
(note #2 in Figure 5-3),
555-233-118