Avaya CMC1 Installation, Upgrades And Additions page 257

Add IP Solutions
From the rear of the cabinet:
2. Connect the Amphenol connector on the adapter to the backplane
connector corresponding to each TN2302AP slot.
Connect the Ethernet
1. Connect the network cable(s) to the Ethernet connector on the TN2302AP
Amphenol adapter(s).
Install the Circuit Packs
!
CAUTION:
When adding or replacing any hardware, be sure to ground yourself against
electrostatic discharge (ESD) by wearing a grounded wrist strap.
NOTE:
The TN799B/C and TN2302AP circuit packs are hot-swappable, so you do
not need to power down the carrier or cabinet to install them.
If you are replacing the existing TN799 circuit pack, remove it first and
replace it with the new TN799B/C.
NOTE:
To properly seat the circuit pack, push firmly on the front of the faceplate
until the latch reaches the bottom rail of the carrier. Then close the latch until
it is fully engaged.
1. Insert the TN799B/C circuit pack into the port slot identified earlier.
2. Insert and latch the TN2302AP IP Media Processor into the port slot you
reserved for it (see
When you plug in the TN2302AP IP Media Processor, the circuit pack
starts to boot. The RED LED stays on until an IP address is assigned to the
circuit pack.
3. Type list configuration all and press
recognizes the TN2302AP circuit packs.
555-233-118
NOTE:
You need a CAT5 or better cable for 100-Mbyte operation.
Figure 5-6).
to verify that the system
Enter
Issue 5 October 2002
5-55