Avaya CMC1 Installation, Upgrades And Additions page 241

Add Integrated Announcements/TN2501AP
2. Type a unique name in the Name field.
3. Enter the IP address in the IP Address field.
You can get this information from the network manager.
4. Press
change ip-interfaces
Use this command to administer an IP interface, which associates the circuit pack
with an IP address.
1. At the SAT, type change ip-interfaces and press
The IP Interfaces screen appears.
change ip-interfaces
Enable
Eth Pt Type Slot
y C-LAN 01C16 TN799
y MEDPRO 01E04 TN2302
y VAL 01C08 TN2501
n
n
n
n
n
n
n
n
n
n
n
n
Screen 5-15. IP Interfaces screen (change ip-interfaces)
2. Set the Enable Eth Pt field to y.
3. Set the Type field to VAL.
4. Type the circuit pack location in the Slot field (UUCSS). In the example
above the slot is 01C08, meaning Cabinet 1, carrier C, slot 8.
5. If a TN2501AP circuit pack is not at this location when you submit the
screen, the system prompts you to enter a VAL circuit pack location.
555-233-118
NOTE:
This name is recognized only within the switch, and does not need to
match the node name on the local network.
to save the changes.
ENTER
IP INTERFACES
Code Sfx Node Name
C st12clan
st12prowler#1
VAL#1
RETURN
Page 1 of
Subnet Mask Gateway Address Rgn
255.255.0 .0 172.22 .22 .254 1
255.255.0 .0 172.22 .22 .254 1
255.255.0 .0 172.22 .22 .254
255.255.255.0 .
255.255.255.0 .
255.255.255.0 .
255.255.255.0 .
255.255.255.0 .
255.255.255.0 .
255.255.255.0 .
255.255.255.0 .
255.255.255.0 .
255.255.255.0 .
255.255.255.0 .
255.255.255.0 .
Issue 5 October 2002
.
6 SPE A
Net
. .
. .
. .
. .
. .
. .
. .
. .
. .
. .
. .
. .
5-39