Avaya CMC1 Installation, Upgrades And Additions page 256

Adding or Removing Hardware
Figure Notes
1. Amphenol connector to backplane
connector corresponding to
TN2302AP slot
Figure 5-5. TN2302AP Amphenol Adapter
Installing the TN2302AP IP Media Processor
To install a TN2302AP IP Media Processor, you must install
One or more TN2302AP circuit pack(s).
One or more TN799B/C circuit pack(s) (a TN799B/C can support more
than one TN2302AP).
An IP Media Processor adapter.
Connect the cables for TN799B/C
1. Determine into which port slots you are putting the TN799B/C C-LAN
circuit packs.
From the rear of the cabinet:
2. Connect a 259A connector to the backplane connector corresponding to
each TN799B/C slot.
3. Connect one end of each DW8 cable to each 259A connector.
Connect the cables for TN2302AP
1. Determine into which port slots you are putting the TN2302AP IP Media
Processor circuit packs.
5-54
Issue 5 October 2002
3
1
addfipm2 KLC 083000
2
2. To Ethernet
3. 9-pin connector for maintenance
555-233-118