Avaya CMC1 Installation, Upgrades And Additions page 64

Installing and Cabling the Cabinets
Data mdule settings
1. Cycle the power to the data module. The unit performs a self test and
displays its operating mode.
2. Observe the display.
a. If the display reads DCE mode, proceed to the next section.
b. If the display reads DTE mode, complete the following steps:
NOTE:
The power LED must be steady on. If the power LED is blinking, the data
module is not communicating with the Avaya CMC1 Media Gateway. Check
the wiring at the MDF, wall jacks, and data module.
Adding a data module
1. Type add data-module number or add data-module next.
2. In the Type field, type pdm and press
3. In the Port field, type the location of the digital line circuit pack connected
to the data module (for example 01A1503).
4. If system access ports and hunt groups have not been set up, set them up.
Refer to Administrator's Guide for Avaya MultiVantage Software.
1-50
Issue 5 October 2002
1. Remove the power cord from the unit.
2. Remove the cover from the top rear of the unit.
3. Remove the mode select circuit board and turn it around.
4. Replace the cover.
5. Connect the power cord.The unit performs a self test.
.
Enter
555-233-118