Set Neon Voltage - Ring Ping - Avaya CMC1 Installation, Upgrades And Additions

Set Neon Voltage — Ring Ping
Set Neon Voltage
NOTE:
If the ringing option is set to 50 Hz, neon voltage is not available. If 25 Hz is selected,
the maximum voltage is 120 volts. Refer to
NOTE:
Set the control to OFF if there are no neon message waiting lamps or if LED message
lamps are used. See
Figure 2-1. Setting the Neon Voltage
1. Call a telephone with a neon message indicator and leave a message.
2. Check for "ring ping" (single ring pulse) each time the lamp flashes
(approximately every 3 seconds).
3. Adjust the control clockwise in small increments until the ring ping stops.
Be sure that the message lamp still lights when the adjustment is finished.
555-233-118
Ring Ping
—
Figure 2-1.
''Set Ringing Option'' on page
didmt1 KLC 053097
Issue 5 October 2002
1-55.
2-7