Adding Or Removing Hardware; Add Circuit Packs - Avaya CMC1 Installation, Upgrades And Additions

Adding or Removing Hardware

This chapter details the information required to install additional port hardware
and other equipment associated with upgrading an existing system.
For more information about installing adjuncts and peripheral devices, refer to
Installation for Adjuncts and Peripherals for Avaya MultiVantage Software.

Add Circuit Packs

When installing additional features or equipment, it may be necessary to install
additional circuit packs. This is a general procedure to use when adding features
or equipment that require adding circuit packs.
1. Log onto the system and answer y to the Suppress Alarm Origination
question during login.
2. Install the circuit pack into the carrier.
3. Type change circuit-pack.
4. Verify the circuit pack appears in the listing.
5. If the circuit pack code is not present, type the code manually in the proper
slot.
6. Type test board long and press
7. Log off the system after the addition (and any required administration) is
complete.
For information about administering circuit packs and other equipment, refer to
Administrator's Guide for Avaya MultiVantage Software.
555-233-118
to test the board.
Enter
Issue 5 October 2002
5
5-1