Avaya CMC1 Installation, Upgrades And Additions page 271

Add IP Solutions
Table 5-10. U.S. Robotics Modem Dip Switch Settings
Dip
Switch Setting
1 UP
DOWN
2 UP
DOWN
3 UP
DOWN
4 UP
DOWN
5 UP
DOWN
6 UP
DOWN
7 UP
DOWN
8 UP
DOWN
Connect the Ethernet
1. Connect the network cable to the ETHERNET connector on the TN802B
external cable assembly.
NOTE:
You need a CAT5 or better cable for 100-Mbyte operation.
Install the Circuit Packs
!
CAUTION:
When adding or replacing any hardware, be sure to ground yourself against
electrostatic discharge (ESD) by wearing a grounded wrist strap.
NOTE:
The TN799B and TN802B circuit packs are hot-swappable, so you do not
need to power down the carrier to install them.
If you need to remove the TN802B IP Interface from the carrier at a later
time, shut down Windows NT first by pressing the recessed reset button on
the faceplate (see
the LCD shows a flashing MSHUT *. When the flashing stops and the
asterisk disappears (about 2 min), it is safe to remove the circuit pack.
555-233-118
Description
Data Terminal Ready normal
Data Terminal Ready override
Verbal result codes
Numeric result codes
Suppress result codes
Display result codes
Echo offline commands
No echo, offline commands
Auto answer on first ring or higher if specified in NVRAM
Auto answer off
Carrier detect normal
Carrier detect override
Load NVRAM defaults
Load factory defaults
Dumb mode
Smart mode
Figure 5-9 on page 5-70) of the TN802B IP Interface until
Issue 5 October 2002
5-69