Avaya CMC1 Installation, Upgrades And Additions page 302

Adding or Removing Hardware
Mounting with a backing plate
NOTE:
Note: the J58890CG Power Distribution Unit should be installed to the right
of the SCC Cabinet Stack, and mounted approximately 12 inches (30.5 cm)
off the floor.
To install the J58890CG Power Distribution Unit on a wall with a plywood backing
plate, use the following procedure:
1. Hold the unit at the desired location (see Note) and mark the 4 (four) holes
(slots and keyholes) centers with a pencil.
2. Use a level to make sure the unit is straight, set the unit aside and install 2
(two) #12 pan head phillips wood screws (rated for 50 LBS each minimum)
in the top position.
3. Install the power distribution unit onto the top screws.
4. Install the bottom screws through the slots in the power distribution
housing.
5-100
Issue 5 October 2002 555-233-118