Avaya CMC1 Installation, Upgrades And Additions page 280

Adding or Removing Hardware
Table 5-12. U.S. Robotics Modem Dip Switch Settings
Dip
Switch Setting
1 UP
DOWN
2 UP
DOWN
3 UP
DOWN
4 UP
DOWN
5 UP
DOWN
6 UP
DOWN
7 UP
DOWN
8 UP
DOWN
Connect the Monitor, Keyboard, and Mouse
NOTE:
Only make these connections if administered locally. Not necessary if
administered remotely.
You must connect these before inserting the TN802B IP Interface.
1. Attach a VGA monitor to the VGA connector of the TN802B IP Interface
external cable assembly.
2. Attach the keyboard to the KEYBOARD connector of the external cable
assembly.
3. Attach the mouse to the MOUSE connector of the external cable assembly.
4. Plug the monitor into an AC power receptacle and turn it on.
5-78
Issue 5 October 2002
Description
Data Terminal Ready normal
Data Terminal Ready override
Verbal result codes
Numeric result codes
Suppress result codes
Display result codes
Echo offline commands
No echo, offline commands
Auto answer on first ring or higher if specified in NVRAM
Auto answer off
Carrier detect normal
Carrier detect override
Load NVRAM defaults
Load factory defaults
Dumb mode
Smart mode
555-233-118