Avaya CMC1 Installation, Upgrades And Additions page 214

Adding or Removing Hardware
4. If you are self-downloading to a TN2501AP (VAL) circuit pack, reseat the
pack:
!
!
a. Release the latch handle to free the circuit pack from the carrier.
b. Pull the circuit pack out approximately 1 – 2 inches (~ 3 – 5 cm).
c. Re-insert the circuit pack into the carrier.
d. Close the latch securely.
Check specified resources
This procedure checks the header on the new firmware image file to ensure that
the firmware download will run as you intend.
1. Type test firmware download and press
The Test Results screen
test firmware download
Port Maintenance Name
FW-DWNLD
Screen 5-3. Test Results screen
2. Look in the Result field for FAIL conditions.
3. If the test does not pass, refer to the proper maintenance book in the
FW-DWNLD section and resolve every error.
4. Re-run the test (test firmware download).
When the test passes, every specified resource is available for the scheduled
download.
5-12
Issue 5 October 2002
(C-LAN) and TN2501AP (VAL) circuit packs either until they are reset
or until you issue the disable filesystem board UUCSS command.
WARNING:
To prevent electrostatic discharge (ESD), be sure to wear a
grounding strap while handling the circuit pack.
CAUTION:
Ensure that both the top green and top amber LEDs are out.
(Screen
TEST RESULTS
Alt. Name Test No. Result
.
Enter
5-3) appears.
1413 PASS
SPE A
Error Code
555-233-118