Avaya CMC1 Installation, Upgrades And Additions page 266

Adding or Removing Hardware
Administration
1. Administer the TN799B/C C-LAN, if necessary. Refer to the Administration
for Network Connectivity for Avaya MultiVantage Software.
2. Administer the IP Media Processor, which is usually done remotely. Call
your service representative to start the process.
3. Complete the administration and testing. Refer to
Steps for C-LAN and IP Media Processor'' on page 5-56
External Connection to the LAN'' on page
Add IP Interface Assembly
The IP Interface is an assembly composed of a TN802B circuit board, a processor
card, and DSP resource card. For ordering purposes, the assembly is identified as
a J58890MA-1 L30, but for simplicity, we refer to it as the TN802B IP Interface.
The TN802B IP Interface operates in two modes
IP Trunk mode is Internet Telephone Server—Enterprise (ITS-E)
compatible
Media Processor (MedPro) mode is H.323 compatible.
The TN802B IP Interface is backwards compatible and defaults to IP Trunk mode.
You must administer it to use it in MedPro mode.
The following sections describe the process for
Installing in Media Processor Mode
Installing in IP Trunk Mode
Upgrading a TN802 V3 (or later) to a TN802B (MedPro mode)
!
WARNING:
When connected remotely via pcANYWHERE, only use the pcANYWHERE
Restart Host Computer button on the toolbar to restart Windows NT.
Installing in Media Processor Mode
To operate in MedPro mode, you must install the TN802B IP Interface and, if the
system does not have one, you must also install and administer a TN799B C-LAN
circuit pack. For C-LAN administration, refer to Administration for Network
Connectivity for Avaya MultiVantage Software.
If you have existing TN802 IP Interface circuit packs, you can upgrade them either
by replacing the circuit pack with a TN802B or by downloading the TN802B
firmware onto the circuit packs (see
5-64
Issue 5 October 2002
''Initial Administration
5-58.
''Upgrade to TN802B (R8)'' on page
and ''Test the
5-92).
555-233-118