Trane TR200 Series Programming Manual page 52

[121] gal/s
[122] gal/min
[123] gal/h
[124] CFM
[125] ft³/s
[126] ft³/min
[127] ft³/h
[130] lb/s
[131] lb/min
[132] lb/h
[140] ft/s
[141] ft/min
[145] ft
[160] °F
[170] psi
[171] lb/in²
[172] in WG
[173] ft WG
[174] in Hg
[180] HP
0-31 Custom Readout Min Value
Range:
0.00 [0.00 - 100.00 CustomRea-
Custom- doutUnit]
Readou-
tUnit*
0-32 Custom Readout Max Value
Range:
100.00 [par. 0-31 - 999999.99 Cus-
Custom- tomReadoutUnit]
Readou-
tUnit*
0-37 Display Text 1
Range:
0 N/A* [0 - 0 N/A]
TR200 Programming Guide
Function:
This parameter allows the choice of the min. value of the custom defined
readout (occurs at zero speed). It is only possible to select a value differ-
ent to 0 when selecting a linear unit in par.0-30
For Quadratic and Cubic units the minimum value will be 0.
Function:
This parameter sets the max value to be shown when the speed of the
motor has reached the set value for par.4-13
[RPM] or par.4-14 Motor Speed High Limit [Hz]
par.0-02 Motor Speed Unit).
Function:
In this parameter it is possible to write an individual text string for display
in the keypad or to be read via serial communication. If to be displayed
permanently select Display Text 1 in par.0-20
0-21 Display Line 1.2 Small, par.0-22
0-23 Display Line 2 Large or par.0-24
▼
buttons on the keypad to change a character. Use the
to move the cursor. When a character is highlighted by the cursor, it can
▲ ▼
be changed. Use the or
A character can be inserted by placing the cursor between two characters
▲ ▼
and pressing or .
Parameter Description
Custom Readout
Motor Speed High Limit
(depends on setting in
Display Line 1.1
Display Line 1.3 Small, par.
Display Line 3 Large. Use the
buttons on the keypad to change a character.
Unit.
Small, par.
▲
or
◀ ▶
and buttons
51