Trane TR200 Series Programming Manual page 157

Parameter Description
[2] Initialisation
[3] Boot mode
14-23 Typecode Setting
Option:
14-25 Trip Delay at Torque Limit
Range:
60 s* [0 - 60 s]
14-26 Trip Delay at Inverter Fault
Range:
0. s* [0 - 35 s]
14-28 Production Settings
Option:
[0] * No action
[1] Service reset
[2] Set Production Mode
14-29 Service Code
Range:
0 N/A* [-2147483647 -
2147483647 N/A]
156
Initialization
Select [2] to reset all parameter values to default settings,
except for par.15-03 Power
15-05 Over Volt's. The frequency converter will reset during the next
power-up.
par.14-22 Operation Mode
operation
[0].
Function:
Typecode re-writing. Use this parameter to set the typecode matching
the specific FC.
Function:
Enter the torque limit trip delay in seconds. When the output torque rea-
ches the torque limits (par.4-16
4-17 Torque Limit Generator
torque limit warning has been continuously present for the period speci-
fied in this parameter, the frequency converter trips. Disable the trip
delay by setting the parameter to 60 s = OFF. Thermal frequency con-
verter monitoring will still remain active.
Function:
When the frequency converter detects an over-voltage in the set time trip
will be effected after the set time.
Function:
Function:
Service use only.
Up's, par.15-04 Over Temp's
will also revert to the default setting
Torque Limit Motor Mode
Mode), a warning is triggered. When the
TR200 Programming Guide
and par.
Normal
and par.