Trane TR200 Series Programming Manual page 30

Parameter
par.0-01 Language
par.1-20 Motor Power [kW]
par.1-21 Motor Power [HP]
par.1-22 Motor Voltage*
par.1-23 Motor Frequency
par.1-24 Motor Current
par.1-25 Motor Nominal Speed
par.1-28 Motor Rotation Check
par.3-41 Ramp 1 Ramp up Time
par.3-42 Ramp 1 Ramp Down Time
par.4-11 Motor Speed Low Limit [RPM]
par.4-12 Motor Speed Low Limit
par.4-13 Motor Speed High Limit [RPM]
par.4-14 Motor Speed High Limit
par.3-19 Jog Speed [RPM]
par.3-11 Jog Speed [Hz]*
Par.5-12 Terminal 27 Digital Input
par.5-40 Function Relay**
Table 3. 1: Quick Setup parameters
*The display showing depends on choices made in par.0-02
The default settings of par.0-02
the world the frequency converter is supplied to but can be re-programmed as required.
** par.5-40 Function Relay, is an array, where one may choose between Relay1 [0] or Relay2 [1]. Standard setting
is Relay1 [0] with the default choice Alarm [9].
See the parameter description in the section
For a detailed information about settings and programming, please see the
NOTE: If [No Operation] is selected in par.5-12
is necessary to enable start.
If [Coast Inverse] (factory default value) is selected in par.5-12
is necessary to enable start.
TR200 Programming Guide
[Units]
[kW]
[HP]
[V]
[Hz]
[A]
[RPM]
[Hz]
[s]
[s]
[RPM]
[Hz]* [Hz]
[RPM]
[Hz]* [Hz]
[RPM]
[Hz]
Motor Speed Unit and par.0-03
Commonly Used Parameters
Terminal 27 Digital
Motor Speed Unit and par.0-03
Regional Settings depend on which region of
.
TR200 Programming Guide
Input, no connection to +24 V on terminal 27
Terminal 27 Digital Input, a connection to +24V
How to Program
Regional Settings.
29