Trane TR200 Series Programming Manual page 28

Example of changing parameter data
Assume parameter 22-60 is set to [Off]. However, you want to monitor the fan-belt condition - non- broken or
broken - according to the following procedure:
1. Press Quick Menu key
2.
Choose Function Setups with the [
3. Press [OK]
4.
Choose Application Settings with the [
5. Press [OK]
6. Press [OK] again for Fan Functions
7. Choose Broken Belt Function by pressing [OK]
▼
8.
With [ ] button, choose [2] Trip
The frequency converter will now trip if a broken fan-belt is detected.
Select [My Personal Menu] to display personal parameters:
Select [My Personal Menu] to display only the parameters, which have been pre-selected and programmed as
personal parameters. For example, you may have pre-programmed personal parameters to be in My Personal
Menu during factory commissioning to make on-site commissioning/fine tuning simpler. These parameters are
selected in par.0-25 My Personal
Select [Changes Made] to get information about:
• The last 10 changes. Use the up/down navigation keys to scroll between the last 10 changed parameters.
• The changes made since default setting.
Select [Loggings]:
to get information about the display line read-outs. The information is shown as graphs.
Only display parameters selected in par.0-20
viewed. It is possible to store up to 120 samples in the memory for later reference.
Quick Setup
Efficient Parameter Set-up for TR200 Applications:
The parameters can easily be set up for the vast majority of the TR200 applications only by using the [Quick
Setup] option.
After pressing [Quick Menu], the different choices in the Quick Menu are listed. See also illustration 6.1 below
and tables Q3-1 to Q3-4 in the following
TR200 Programming Guide
▼
] button
▼
] button
Menu. Up to 20 different parameters can be programmed in this menu.
Display Line 1.1 Small
Function Setups
section.
How to Program
and par.0-24 Display Line 3 Large can be
27