Trane TR200 Series Programming Manual page 128

8-06 Reset Control Timeout
Option:
[0] * Do not reset
[1] Do reset
8-07 Diagnosis Trigger
Option:
[0] * Disable
[1] Trigger on alarms
[2] Trigger alarm/warn.
8-1* Ctrl. Word Settings
Parameters for configuring the option control word profile.
8-10 Control Profile
Option:
[0] * FC profile
[1] PROFIdrive profile
[5] ODVA
[7] CANopen DSP 402
8-13 Configurable Status Word STW
Option:
[0] No function
[1] * Profile Default
[2] Alarm 68 Only
[3] Trip excl Alarm 68
[16] T37 DI status
TR200 Programming Guide
Function:
This parameter is active only when the choice
selected in par.8-05 End-of-Timeout Function
Retains the set-up specified in par.8-04
setup 1-4] following a control time-out.
Returns the frequency converter to the original set-up following a control
word time-out. When the value is set to
verter performs the reset and then immediately reverts to the
reset
[0] setting.
Function:
This parameter has no function for LonWorks.
Function:
Select the interpretation of the control and status words corresponding
to the installed fieldbus. Only the selections valid for the fieldbus instal-
led in slot A will be visible in the keypad display.
Function:
This parameter enables configuration of bits 12 – 15 in the status word.
Function corresponds to the profile default selected in par.8-10
Profile.
Only set in case of an Alarm 68.
Set in case of a trip, except if the trip is executed by an Alarm 68.
The bit indicates the status of terminal 37.
"0" indicates T37 is low (safe stop)
"1" indicates T37 is high (normal)
Parameter Description
Hold set-up
[0] has been
.
Control Timeout Function, [Select
Do reset
[1], the frequency con-
Do not
Control
127