Arp Command Parameters - Avaya CallPilot 600r Maintenance And Diagnostics

Using Windows online diagnostic tools

ARP command parameters

Table 12: ARP command parameters
Parameter
-a
-g
inet_addr
if_addr
eth_addr
-N if_addr
-d
-s
To run the ARP command from Windows
1. Click Start → Programs → Accessories → Command Prompt.
2. At the Command prompt, type arp with the required parameters (for example, arp
3. Press Enter.
4. Type Exit to exit the Command Prompt window and return to Windows.
38 Avaya CallPilot® 600r Server Maintenance and Diagnostics
Displays current ARP entries by interrogating the current
protocol data. If inet_addr is specified, the IP and physical
addresses for only the specified computer appear. If more than
one network interface uses ARP, entries for each ARP table
appear.
Same as -a.
Specifies an Internet address.
Specifies the Internet address of the interface where you can
modify the address translation table. If not present, the first
applicable interface is used.
Specifies a physical address.
Displays the ARP entries for the network interface specified by
if_addr.
Deletes the host specified by inet_addr.
Adds the host and associates the Internet address inet_addr
with the physical address eth_addr. The physical address is
given as six hexadecimal bytes separated by hyphens. The
entry is permanent.
Result: The Command Prompt window appears.
-g 200.286.0.32).
Result: The system runs the ARP command.
Description
December 2010