Arp Command Parameters; The Nbtstat Command - Avaya CallPilot 1005r Maintenance And Diagnostics

Using Windows online diagnostic tools

ARP command parameters

Table 8: ARP command parameters
-a
-g
inet_addr
if_addr
eth_addr
-N if_addr
-d
-s
To run the arp command from Windows
1. Click Start > Programs > Accessories > Command Prompt.
2. Type arp with the required parameters (for example, arp -g 200.286.0.32).
3. Press Enter.
4. Type Exit to exit the Command Prompt dialog box and return to Windows.

The nbtstat command

The nbtstat command displays protocol statistics and current TCP/IP connections using NBT.
36 Avaya CallPilot® 1005r Server Maintenance and Diagnostics
Parameter
Result: The Command Prompt dialog box appears.
Result: The system runs the arp command.
Description
Displays current arp entries by interrogating the
current protocol data. If inet_addr is specified, the IP
and physical addresses for the specified computer
appear. If more than one network interface uses arp,
entries for each arp table appear.
Same as -a.
Specifies an Internet address.
Specifies the Internet address of the interface where
the address translation table can be modified. If not
present, the first applicable interface is used.
Specifies a physical address.
Displays the arp entries for the network interface
specified by if_addr.
Deletes the host specified by inet_addr.
Adds the host and associates the Internet address
inet_addr with the physical address eth_addr. The
physical address is given as six hexadecimal bytes
separated by hyphens. The entry is permanent.
December 2010