Component - Supermicro SSE-X3348T/R User Manual

1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User's Manual
Table 5-125. PIM Basic Settings Page Parameters (Continued)
Parameter
Registration Stop
Rate Limiting Period
PMBR Status
Static RP

Component

Clicking the C
OMPONENT
(Figure 5-149). The parameters for this page are shown in
Table 5-126. PIM Component Configuration Page Parameters
Parameter
Component ID
Candidate CRP Hold
Time
Mode
BSR Address
BSR Expiry Time
Description
This parameter specifies the registration stop rate limiting period in seconds.
This parameter allows you to enable or disable the PMBR status in the switch.
This parameter allows you to enable or disable the Static RP in the switch.
Figure 5-149. PIM Component Configuration Page
tab brings up the PIM C
Description
This parameter specifies a number uniquely identifying the component.
This parameter specifies the hold time of the component when it is a candidate
RP in the local domain.
This parameter specifies the mode of the component. It can be Sparse or Dense.
This parameter specifies the IP address of the bootstrap router for the local PIM
region, which is a read-only field.
This parameter indicates the minimum time remaining before the bootstrap
router in the local domain is declared down, which is a read-only field.
OMPONENT
5-176
C page
ONFIGURATION
Table 5-126.