European Standards; Ce Low Voltage Directive Compliance - YASKAWA A1000 Series Quick Start Manual

C.1 European Standards
C.1 European Standards
The CE mark indicates compliance with European safety and environmental regulations. It is required for engaging in business
and commerce in Europe.
European standards include the Machinery Directive for machine manufacturers, the Low Voltage Directive for electronics
manufacturers, and the EMC guidelines for controlling noise.
This drive displays the CE mark based on the EMC guidelines and the Low Voltage Directive.
• Low Voltage Directive: 2014/35/EU
• EMC Guidelines: 2014/30/EU
Devices used in combination with this drive must also be CE certified and display the CE mark. When using drives displaying
the CE mark in combination with other devices, it is ultimately the responsibility of the user to ensure compliance with CE
standards. After setting up the device, verify that conditions meet European standards.
u

CE Low Voltage Directive Compliance

This drive has been tested according to European standard IEC/EN 61800-5-1:2007, and it fully complies with the Low Voltage
Directive.
To comply with the Low Voltage Directive, be sure to meet the following conditions when combining this drive with other
devices:
n
Area of Use
Do not use drives in areas with pollution higher than degree 2 and overvoltage category 3 in accordance with IEC/EN 60664.
n Factory Recommended Branch Circuit Protection
Yaskawa recommends installing one of the following types of branch circuit protection to maintain compliance with UL508C.
Semiconductor protective type fuses are preferred. Alternate branch circuit protection devices are also listed in
NOTICE: If a fuse is blown or a Ground Fault Circuit Interrupter (GFCI) is tripped, check the wiring and the selection of peripheral devices
to identify the cause. Contact Yaskawa before restarting the drive or the peripheral devices if the cause cannot be identified.
Drive Model
2A0004
2A0006
2A0008
2A0010
2A0012
2A0018
2A0021
2A0030
2A0040
2A0056
2A0069
2A0081
2A0110
2A0138
330
Figure C.1 CE Mark
Table C.1 Factory Recommended Drive Branch Circuit Protection
Model
Three-Phase 200 V Class
FWH-70B
FWH-70B
FWH-70B
FWH-70B
FWH-70B
FWH-90B
FWH-90B
FWH-100B
FWH-200B
FWH-200B
FWH-200B
FWH-300A
FWH-300A
FWH-350A
YASKAWA ELECTRIC TOEP C710616 41G YASKAWA AC Drive - A1000 Quick Start Guide
Fuse Type
Manufacturer: Bussmann
Fuse Ampere Rating (A)
Table C.1.
70
70
70
70
70
90
90
100
200
200
200
300
300
350