Throttle Body Reassembly - Suzuki GSX-R1000 2007 Service Manual

5-20 FUEL SYSTEM AND THROTTLE BODY

THROTTLE BODY REASSEMBLY

Reassemble the throttle body in the reverse order of disassem-
bly. Pay attention to the following points:
• With the secondary throttle valves fully opened, install the
STP sensor and tighten the STP sensor mounting screw to
the specified torque.
NOTE:
* Apply thin coat of engine oil to the O-ring.
* Align the secondary throttle shaft end " with the groove # of
STP sensor.
* Apply grease to the secondary throttle shaft end " if neces-
sary.
X 99000-25010: SUZUKI SUPER GREASE "A"
\ 09930-11950: Torx wrench
" STP sensor mounting screw: 3.5 N·m (0.35 kgf-m, 2.5lb-ft)
NOTE:
* Make sure the secondary throttle valves smoothly open and
close.
* If the STP sensor adjustment is necessary, refer to page 5-23
for STP sensor setting procedure.
• With the throttle valves fully closed, install the TP sensor
and tighten the TP sensor mounting screw to the specified
torque.
NOTE:
* Apply thin coat of engine oil to the O-ring.
* Align the throttle shaft end $ with the groove % of TP sensor.
* Apply grease to the throttle shaft end $ if necessary.
X 99000-25010: SUZUKI SUPER GREASE "A"
\ 09930-11950: Torx wrench
" TP sensor mounting screw: 3.5 N·m (0.35 kgf-m, 2.5lb-ft)
NOTE:
* Make sure the throttle valves smoothly open and close.
* TP sensor setting procedure. ( 4-21)
or equivalent
or equivalent