Suzuki GSX-R1000 2007 Service Manual page 210

Step 1 (When indicating P0110-L:)
1) Turn the ignition switch OFF.
2) Lift and support the fuel tank. ( 5-3)
3) Check the IAT sensor coupler
If OK, then check the IAT sensor lead wire continuity.
4) Disconnect the IAT sensor coupler.
5) Check the continuity between Dg wire
sound is not heard from the tester, the circuit condition is OK.
= Tester knob indication: Continuity test (?)
6) Connect the IAT sensor coupler and turn the ignition switch
ON.
7) Measure the voltage between Dg wire
IAT sensor output voltage: 0.15 – 4.85 V
\ 09900-25008: Multi-circuit tester set
09900-25009: Needle pointed probe set
W Tester knob indication: Voltage ()
Are the continuity and voltage OK?
YES Go to Step 2.
• Dg wire shorted to ground
NO
• If wire is OK, go to Step 2.
8) After repairing the trouble, clear the DTC using SDS tool.
( 4-28)
for loose or poor contacts.
and ground. If the
and ground.
( Dg – Ground)
FI SYSTEM DIAGNOSIS 4-55
1
1
1
V