Suzuki GSX-R1000 2007 Service Manual page 152

3-102 ENGINE
CAM CHAIN TENSION ADJUSTER
• Retract the push rod by pushing the stopper
• Fit a new gasket
Use a new gasket to prevent oil leakage.
• Install the cam chain tension adjuster
to the top side.
" Cam chain tension adjuster mounting bolt:
• Install the spring
• Install the gasket washer
NOTE:
Click sound is heard when the cam chain tension adjuster cap
bolt is installed.
• Tighten the cam chain tension adjuster cap bolt to the speci-
fied torque.
" Cam chain tension adjuster cap bolt:
After installing the cam chain tension adjuster, check
to be sure that the adjuster works properly by check-
ing the slack of cam chain.
• Remove the wire clamps
• After installing the cam chain tension adjuster, rotate the
crankshaft (some turns), and recheck the positions of the
camshafts. ( 3-103)
.
with "UP" mark faced
10 N·m (1.0 kgf-m, 7.0 lb-ft)
.
and cap bolt
23 N·m (2.3 kgf-m, 16.5 lb-ft)
.
.
.
"UP" "UP"