Suzuki GSX-R1000 2007 Service Manual page 452

9-18 ELECTRICAL SYSTEM
GEAR POSITION SENSOR
• Lift and support the fuel tank. (
• Disconnect the gear position switch coupler  and check the
continuity between Bl and B/W with the transmission in "NEU-
TRAL".
09900-25008: Multi-circuit tester set
Tester knob indication: Continuity test (
ON (Neutral)
OFF (Except neutral)
When disconnecting and connecting the gear position
switch coupler, make sure to turn OFF the ignition
switch, or electronic parts may get damaged.
• Connect the gear position switch coupler to the wiring har-
ness.
• Turn the ignition switch ON and side-stand to upright position.
• Measure the voltage between P and B/W lead wires using the
multi-circuit tester when shifting the gearshift lever from low to
top.
09900-25008: Multi-circuit tester set
09900-25009: Needle pointed probe set
Tester knob indication: Voltage (
Gear position switch voltage: 0.6 V and more
* Low to top gear position (P – B/W )
* Except neutral position (P – B/W )
Use the special tool, to prevent the rubber of the water
proof coupler from damage.
5-3)
)
Bl B/W
)
V