Suzuki GSX-R1000 2007 Service Manual page 206

Step 1 (When indicating P0115-L:)
1) Turn the ignition switch OFF.
2) Lift and support the fuel tank. ( 5-3)
3) Check the ECT sensor coupler
If OK, then measure the output voltage.
4) Disconnect the ECT sensor coupler.
5) Check the continuity between B/Bl wire
If the sound is not heard from the tester, the circuit condition
is OK.
= Tester knob indication: Continuity test (?)
6) Connect the ECT sensor coupler and turn the ignition switch
ON.
7) Measure the voltage between B/Bl wire
ECT sensor output voltage: 0.15 – 4.85 V
\ 09900-25008: Multi-circuit tester set
09900-25009: Needle pointed probe set
W Tester knob indication: Voltage ()
Are the continuity and voltage OK?
YES Go to Step 2.
• B/BI wire shorted to ground
NO
• If wire is OK, go to Step 2.
8) After repairing the trouble, clear the DTC using SDS tool.
( 4-28)
for loose or poor contacts.
and ground.
and ground.
( B/BI – Ground)
FI SYSTEM DIAGNOSIS 4-51
1
1
1
V