Inspection - Suzuki GSX-R1000 2007 Service Manual

9-30 ELECTRICAL SYSTEM

INSPECTION

LED (LIGHT EMITTING DIODE)
Check that the LED lights [FI light, Fuel level indicator light, Engine revolution indicator lamp and immobilizer
indicator light (For E-02, 19, 24)] immediately after turning the ignition switch ON. Also, other LED lights
(Neutral indicator light, High-beam indicator light and Turn signal indicator light) can be checked by depend-
ing on each switch position.
If the LED fails in operation, replace the combination meter unit with a new one after checking its wire har-
ness/coupler.
STEPPING MOTOR
Check that the pointer calibrates itself immediately after turning the ignition switch ON and stops at zero
point.
If abnormal condition is found, replace the combination meter unit with a new one after checking its wire har-
ness/coupler.
NOTE:
The pointer may not return to the proper position even turning the ignition switch ON under low temperature
condition. In that case, you can reset the pointer to the proper position by following the instruction below:
1) With the adjuster switch " pressed, turn the ignition switch ON.
2) Release the adjuster switch ", 3 to 5 seconds after turning the ignition switch ON.
3) Press the adjuster switch " twice (within 1 second). →Reset
* Complete the operation within 10 seconds after the ignition switch has been turned ON.
Time Ignition switch
OFF
0
ON
•
•
3 sec.
•
5 sec.
•
•
•
•
10 sec.
Pointer will return to the starting point right after the completion of the operation. In the case of the pointer
not returning to the proper position after doing above, replace the combination meter unit.
Adjuster switch
PUSH
Release
Push
Push→Reset