Suzuki GSX-R1000 2007 Service Manual page 162

Continuity check
• Measure resistance across coupler
the figure).
If no continuity is indicated (infinity or over limit), the circuit is
open between terminals
• Disconnect the coupler
couplers and .
If no continuity is indicated, the circuit is open between cou-
plers and . If continuity is indicated, there is an open cir-
cuit between couplers
' or coupler .
VOLTAGE CHECK
If voltage is supplied to the circuit being checked, voltage check
can be used as circuit check.
• With all connectors/couplers connected and voltage applied
to the circuit being checked, measure voltage between each
terminal and body ground.
If measurements were taken as shown in the figure at the right
and results are as listed below, it means that the circuit is open
between terminals and
Voltage Between:
and body ground: Approx. 5 V
and body ground: Approx. 5 V
and body ground:
Also, if measured values are as listed below, a resistance
(abnormality) exists which causes the voltage drop in the circuit
between terminals and
Voltage Between:
and body ground: Approx. 5 V
and body ground: Approx. 5 V
and body ground:
(between
and .
and measure resistance between
' and or an abnormality in coupler
.
0 V
.
2 V voltage drop
3 V
and in
ECM
ECM
FI SYSTEM DIAGNOSIS 4-7
5 V
5 V
0 V
5 V