Suzuki GSX-R1000 2007 Service Manual page 453

TURN SIGNAL/SIDE-STAND RELAY
The turn signal/side-stand relay is composed of the turn signal
relay, side-stand relay and diode.
• Remove the turn signal/side-stand relay .
SIDE-STAND RELAY INSPECTION
First check the insulation between % and & terminals with the
tester. Then apply 12 V to terminals % and $ ( to % and  to
$) and check the continuity between % and &. If there is no
continuity, replace the turn signal/side-stand relay with a new
one.
09900-25008: Multi-circuit tester set
Tester knob indication: Continuity test (
DIODE INSPECTION
Measure the voltage between the terminals using the multi-cir-
cuit tester. Refer to the following table.
$, #
"
09900-25008: Multi-circuit tester set
Tester knob indication: Diode test (
NOTE:
If the multi circuit tester reads 1.4 V and below when the tester
probes are not connected, replace its battery.
Probe of tester to:
$, #
1.4 V and more
(Tester's battery voltage)
0.4 – 0.6 V
)
"
)
ELECTRICAL SYSTEM 9-19
SIDE-STAND RELAY
DIODE
TURN
SIGNAL
RELAY