Suzuki GSX-R1000 2007 Service Manual page 328

• Install the rubber seal
• After wiping off the oily or greasy matter from the mechanical
seal ring, install it into the impeller.
NOTE:
The paint marked side # of mechanical seal ring faces the rub-
ber seal.
• Install the washer
securing bolt .
NOTE:
The metal side $ of seal washer and the curved side % of
washer face the impeller securing bolt head.
• Install the impeller
• Tighten the impeller securing bolt to the specified torque.
" Impeller securing bolt: 8 N·m (0.8 kgf-m, 6.0 lb-ft)
NOTE:
Before installing the impeller securing bolt, apply a small quan-
tity of the thread lock to it.
H 99000-32110: THREAD LOCK SUPER "1322"
• Install the new O-rings
Use the new O-rings to prevent engine coolant leak-
age.
NOTE:
* Apply engine coolant to the O-ring
* Apply grease to the O-ring
X 99000-25010: SUZUKI SUPER GREASE "A"
• Tighten the water pump cover screws to the specified torque.
" Water pump cover screw: 5 N·m (0.5 kgf-m, 3.5 lb-ft)
NOTE:
Fit the clamp & to the water pump cover screw.
into the impeller.
and seal washer
and its securing bolt onto the shaft.
and .
.
.
onto the impeller
or equivalent
or equivalent
COOLING AND LUBRICATION SYSTEM 7-15