Suzuki GSX-R1000 2007 Service Manual page 393

CUSHION LEVER BEARING
• Insert the spacer into bearing and check the play when mov-
ing the spacer up and down.
• If excessive play is noted, replace the bearing with a new one.
• Remove the cushion lever bearings with the special tool.
09921-20240: Bearing remover set ( 20 mm)
The removed bearings must be replaced with new
ones.
CUSHION ROD BEARING
• Insert the spacer into bearing and check the play when mov-
ing the spacer up and down.
• If excessive play is noted, replace the bearing with a new one.
• Remove the cushion rod bearings with the special tool.
09921-20240: Bearing remover set (17 mm)
The removed bearings must be replaced with new
ones.
SWINGARM PIVOT SHAFT
• Using a dial gauge, check the pivot shaft runout and replace it
if the runout exceeds the limit.
Swingarm pivot shaft runout:
Service limit: 0.3 mm (0.01 in)
09900-20607: Dial gauge (1/100 mm, 10 mm)
09900-20701: Magnetic stand
09900-21304: V-block set (100 mm)
( 17 mm)
CHASSIS 8-59