Suzuki GSX-R1000 2007 Service Manual page 136

3-86 ENGINE
• Install the generator rotor onto the crankshaft.
• Hold the generator rotor with the special tool and tighten its
bolt to the specified torque.
\ 09930-44520: Rotor holder
" Generator rotor bolt: 120 N·m (12.0 kgf-m, 87.0 lb-ft)
GENERATOR COVER
• Apply bond lightly to the mating surfaces at the parting line
between the upper and middle crankcases as shown.
D 99000-31140: SUZUKI BOND "1207B" or equivalent
• Install the dowel pins and new gasket
Use a new gasket to prevent oil leakage.
• Install the generator cover and tighten the generator cover
bolts to the specified torque.
" Generator cover bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
#
Be careful not to pinch finger between the generator
cover and crankcase.
Use new gasket washers to prevent oil leakage.
NOTE:
* Fit the gasket washers to the bolts ".
* Fit the clamp to the bolt #.
.