Suzuki GSX-R1000 2007 Service Manual page 126

3-76 ENGINE
CRANKSHAFT
• Position the No.2 and No.3 conrod big ends on the same side,
and the No.1 and No.4 conrod big ends on the opposite side
of No.2 and No.3.
• Set the crankshaft to the conrods and upper crankcase.
• Apply a MOLYBDENUM OIL SOLUTION to the crank pin and
bearing surface.
P MOLYBDENUM OIL SOLUTION
Be sure to clean the conrod big end.
• When fitting the conrod cap, make sure that I.D. code " on
each conrod faces intake side.
• Apply engine oil to the bearing cap bolts.
• Tighten the bearing cap bolt by using a 10 mm, 12 point
socket wrench in the following two steps.
" Conrod bearing cap bolt:
Initial: 37 N·m (3.7 kgf-m, 27.0 lb-ft)
Final : 60° (1/6 turn)
• Apply engine oil to the conrod big end side surfaces.
• Check the conrod movement for smooth turning.
60˚