Suzuki GSX-R1000 2007 Service Manual page 434

8-100 CHASSIS
• Stake the joint pin by turning (approximately 7/8 turn) the
pressure bolt "A"  with the bar until the pin end diameter
becomes the specified dimension.
Pin end diameter specification %
DID 5.50 – 5.80 mm (0.217 – 0.228 in)
* After joining of the chain has been completed, check
to make sure that the link is smooth and no abnormal
condition is found.
* Should any abnormal condition be found, reassem-
ble the chain link using the new joint parts.
• Adjust the drive chain, after connecting it. ( 2-22)