MASTER CYLINDER DISASSEMBLY
• Remove the reservoir cap, insulator , diaphragm and
reservoir tank .
• Remove the connector by removing the screw.
• Remove the O-ring .
Replace the O-ring with a new one.
• Pull out the dust boot , then remove the snap ring .
09900-06108: Snap ring pliers
• Remove the push rod , piston/primary cup and spring .
MASTER CYLINDER INSPECTION
CYLINDER, PISTON AND CUP SET
• Inspect the cylinder bore wall for any scratches or other dam-
age.
• Inspect the cup set and each rubber part for damage.
CHASSIS 8-83