I-Fax Switches - Ricoh D127 Field Service Manual

5. Appendix: Fax Service Program
No
0 Not used
Report printout after an original
jam during SAF storage or if the
SAF memory fills up
1
0: Enabled
1: Disabled
2 Not used
Received fax print start timing
(G3 reception)
3
0: After receiving each page
1: After receiving all pages
4-6 Not used
Action when a fax SC has
occurred
7
0: Automatic reset
1: Fax unit stops

I-Fax Switches

I-fax Switch 00 [SP No. 1-102-001]
No
Original size limitation of TX
Attachment File
204
FUNCTION
FUNCTION
COMMENTS
Do not change the settings.
0: When an original jams, or the SAF memory overflows
during scanning, a report will be printed.
Change this bit to "1" if the customer does not want to
have a report in these cases.
Memory tx – Memory storage report
Parallel memory tx – Transmission result report
Do not change the settings.
0: The machine prints each page immediately after the
machine receives it.
1: The machine prints the complete message after the
machine receives all the pages in the memory.
Do not change the factory settings.
0: When the fax unit detects a fax SC code other than
SC1201 and SC1207, the fax unit automatically resets
itself.
1: When the fax unit detects any fax SC code, the fax unit
stops.
Cross Reference
Fax SC codes - See "Troubleshooting"
COMMENTS
These settings set the size applying to adjusting the
transmitted original data so that the destination can
receive within its capacity.