Ricoh D127 Field Service Manual page 184

6. Troubleshooting
[8]
C
[9]
[10]
HDD: Initialization error
860
B
Bad sector number error
862
B
HDD: Read error
863
C
HDD: CRC error
864
C
182
HDD check error:
The HDD is not correctly installed.
Power failure during the data
encryption:
The data encryption (NVRAM and
HDD) has not been completed.
Data read/write error:
The DMAC error is detected twice or
more.
The controller detects that the hard
disk fails.
The number of bad sectors in the
HDD (image data area) goes over
101.
The data stored in the HDD cannot be
read correctly.
While reading data from the HDD or
storing data in the HDD, data
transmission fails.
• No HDD installed
• Unformatted HDD
• The encryption key on the controller
is different from the one on the HDD
1. Install the HDD correctly.
2. Initialize the HDD.
• Power failure during the data
encryption
1. Initialize the HDD.
• Same as SC863
• HDD not initialized
• Defective HDD
1. Reformat the HDD.
1. Replace the HDD.
• Defective HDD
1. Format the HDD with SP5-832-002.
2. Replace the HDD.
• Defective HDD
• Defective controller
1. Replace the HDD.
2. Replace the controller.
• Defective HDD
1. Replace the HDD.