Ricoh D127 Field Service Manual page 414

5. Appendix: Fax Service Program
mm/inch
This setting selects mm/inch conversion for mail transmission.
0: Off (No conversion), 1: On (Conversion)
When on (set to "1"), the machine converts millimeters to inches for sending mail. There is no
switch for converting inches to millimeters.
Unlike G3 fax transmissions which can negotiate between sender and receiver to determine the
setting, mail cannot negotiate between terminals; the mm/inch selection is determined by the
sender fax.
When this switch is Off (0):
7
Images scanned in inches are sent in inches.
Images scanned in mm are sent in mm.
Images received in inches are transmitted in inches.
Images received in mm are transmitted in mm.
When this switch is On (1):
Images scanned in inches are sent in inches.
Images scanned in mm are converted to inches.
Images received in inches are transmitted in inches.
Images received in mm are converted to inches.
I-fax Switch 02 [SP No. 1-102-003]
No
RX Text Mail Header Processing
This setting determines whether the header information is printed with text e-mails when they
are received.
0: Prints only text mail.
0
1: Prints mail header information attached to text mail.
When a text mail is received with this switch On (1), the "From" address and "Subject" address
are printed as header information.
When a mail with only binary data is received (a TIFF-F file, for example), this setting is ignored
and no header is printed.
206
FUNCTION COMMENTS