Ricoh D127 Field Service Manual page 240

3. Appendix: SP Mode Tables
2152 56 LD2 Area 23
2152 57 LD2 Area 24
2152 58 LD2 Area 25
2152 59 LD2 Area 26
2152 60 LD2 Area 27
2152 61 LD2 Area 28
2152 62 LD2 Area 29
2152 63 LD2 Area 30
2152 64 LD2 Area 31
2201* Development Bias Adjust
Printing
Adjusts the voltage applied to the development roller for printing. Image density
2201 1
becomes higher when you specify a smaller value (a greater absolute value). Image
density becomes lower when you specify a greater value (a smaller absolute value).
ID sensor pattern
(0:N 1:H 2:L 3:HH 4:LL)
2201 2
Adjusts the toner density control of the developer case.
[0= Normal / 1= Thick / 2= Thin / 3= More thick / 4= More thin]
ID sensor pattern
2201 3
(Temporally Input)
2210 Bias Off Time
2210 1 Charge Bias
2210 2 Development Bias
2211 PCU Reverse Interval
2211 1 This value affects how many sheets are copied continuously before PCU reversing.
32
[75 to 125 / 100.7 / 0.1 %/step]
[75 to 125 / 100.5 / 0.1 %/step]
[75 to 125 / 100.2 / 0.1 %/step]
[75 to 125 / 99.8 / 0.1 %/step]
[75 to 125 / 99.3 / 0.1 %/step]
[75 to 125 / 98.7 / 0.1 %/step]
[75 to 125 / 97.9 / 0.1 %/step]
[75 to 125 / 97.1 / 0.1 %/step]
[75 to 125 / 96.2 / 0.1 %/step]
[–1500 to –200 / –650 / 10 /step = 1V]
[ 0 to 4 / 0 / 1 /step]
[-700 to -300 / -420 / 10 V/step]
[10 to 150 / 100 / 10 /step]
[10 to 200 / 80 10 /step]
[0 to 999 / 100 / 1 sheet/step]