Ricoh D127 Field Service Manual page 36

2. Installation
13. Pull each tabbed strip [M] out of the PCU with one hand, supporting the PCU with the other.
• Do not pull both strips at the same time, as this could damage the PCU.
14. Close the front door.
15. Pull out the paper tray, and remove the tape securing the end fence in the compartment.
16. Push the bottom plate down, and then load the paper.
17. Adjust the side fences. If you load paper shorter than A4, set the end fence in the correct position.
18. Push the tray back into the copier.
19. Attach the appropriate tray number decal and paper-size decal to the paper tray [N].
20. Install optional units (if any).
34