6. Troubleshooting
5. To exit Card Save mode, Change the Bit Switch Settings back to the default 00000000.
6. After main power switch is turned off, remove the SD card.
Error Messages
Card Save error messages:
• Init error: A card save process (i.e. card detection, change to kernel mode) failed to initialize.
• Card not found: Card cannot be detected in the slot.
• No memory: Insufficient working memory to process the job.
• Write error: Failed to write to the card.
• Other error: An unknown error occurred.
If an error occurs, pressing "OK" will cause the device to discard the job and return to the ready state.
194