Ricoh D127 Field Service Manual page 446

5. Appendix: Fax Service Program
IP Fax bit signal reverse setting
0 0: Maker code setting
1: Internal bit switch setting
IP Fax transmission speed setting
1 0: Modem speed
1: No limitation
SIP transport setting
2 0: TCP
1: UDP
CCM connection
3 0: No CCM connection
1: CCM connection
Message reception selection from non-
registered SIP server
4
0: Answer
1: Not answer
ECM communication setting
5 0: No limit for image compression
1: Limit for image compression
6-7 Not used
IP Fax Switch 03 [SP No. 1-111-004]
No.
Effective field limitation for G3 standard
function information
0
0: OFF, 1: 4byte (DIS)
238
FUNCTION
When "0" is selected, the bit signal reverse method
is decided by the maker code.
When "1" is selected, the bit signal reverse method
is decided by the internal bit switch.
(When communicating between IP Fax devices,
LSB first is selected.)
Selects the transmit speed for IP Fax
communication.
This bit switch sets the transport that has priority for
receiving IP Fax data.
This function is activated only when the sender has
both TCP and UDP.
When "1" is selected, only the connection call
message with H.323 or no tunneled H.245 is
transmitted via CCM.
0: This answers the INVITE message from the SIP
server not registered for the machine.
1: This does not receive the INVITE message from
the SIP server not registered for the machine and
send a refusal message.
0: This does not limit the type of the image
compression with ECM communication.
1: When the other end machine is Ciscco, this
permits the image compression other than JBIG or
MMR with ECM communication.
Do not change these settings.
COMMENTS
Limits the effective field for standard G3 function
information.