Test Pattern Print (Sp2-109-001); Executing Test Pattern Printing - Ricoh D127 Field Service Manual

5. System Maintenance Reference
Data incorrect after download
32
interrupted
33 Incorrect SD card version
Module mismatch - Correct
34
module is not on the SD card)
Module mismatch - Module on
35
SD card is not for this machine
Cannot write module - Cause
36
other than E34, E35
40 Engine module download failed
Operation panel module
42
download failed
Stamp data module download
43
failed
Controller module download
44
failed
Electronic confirmation check
50
failed

Test Pattern Print (SP2-109-001)

Executing Test Pattern Printing

1. Touch the item you want to activate then the item "OK" displayed on the touch panel.
2. Press the key. The copy mode is activated.
3. Specify copy settings and press the
4. To return to the SP mode, Touch the item "To SP" displayed on the upper left corner on the touch
panel.
150
Execute the recovery procedure for the intended
module download, then repeat the installation
procedure.
Incorrect ROM data on the SD card, or data is
corrupted.
SD update data is incorrect. Acquire the correct data
(Japan, Overseas, OEM, etc.) then install again.
SD update data is incorrect. The data on the SD card is
for another machine. Acquire correct update data then
install again.
SD update data is incorrect. The data on the SD card is
for another machine. Acquire correct update data then
install again.
Replace the update data for the module on the SD card
and try again, or replace the BICU board.
Replace the update data for the module on the SD card
and try again, or replace the LCDC.
Replace the update data for the module on the SD card
and try again, or replace the hard disks.
Replace the update data for the module on the SD card
and tray again, or replace controller board.
SD update data is incorrect. The data on the SD card is
for another machine. Acquire correct update data then
install again.
key.