Ricoh D127 Field Service Manual page 416

5. Appendix: Fax Service Program
5-6 Not Used
Image Resolution of RX Text Mail
This setting determines the image resolution of the received mail.
0: 200 x 200
7
1: 400 x 400
The "1" setting requires installation of the Function Upgrade Card in order to have enough SAF
(Store and Forward) memory to receive images at 400 x 400 resolution.
I-fax Switch 03 - Not used (do not change the settings) [ SP No. 1-102-004]
I-fax Switch 04 [SP No. 1-102-005]
No
Subject for Delivery TX/Memory Transfer
This setting determines whether the RTI/CSI registered on this machine or the RTI/CSI of the
originator is used in the subject lines of transferred documents.
0: Puts the RTI/CSI of the originator in the Subject line. If this is used, either the RTI or CSI is
0
used. Only one of these can be received for use in the subject line.
1: Puts the RTI/CSI registered on this machine in the Subject line.
When this switch is used to transfer and deliver mail to a PC, the information in the Subject line
that indicates where the transmission originated can be used to determine automatically the
destination folder for each e-mail.
Subject corresponding to mail post database
0: Standard subject
1: Mail post database subject
The standard subject is replaced by the mail post database subject in the following three cases:
1) When the service technician sets the service (software) switch.
1
2) When memory sending, delivery specified by F code or SMTP reception is done.
3) With relay broadcasting (1st stage without the Schmidt 4 function).
• This switch does not apply for condition 3) when the RX system is set up for memory
sending, delivery by F-code, sending with SMTP RX and when operators are using FOL
(to prevent problems when receiving transmissions).
208
FUNCTION COMMENTS