Ricoh D127 Field Service Manual page 265

Mode Clear Opt. Counter
5120*
Removal
Specifies the condition to reset the copy job settings when the key counter is removed.
• 0: Y = Yes: The settings are cleared when the counter is removed.
• 1: StdBy = Standby only: The settings are cleared when the counter is removed at
5120 1
the end of a job.
• 2: N = No: The settings are not cleared under either condition.
As for duplex copying, the job settings are always preserved regardless of these setting.
5121* Counter Up Timing
Selects the count-up timing.
5121 1 • 0 = Feed: At each paper feed
• 1= Exit: At each paper exit
5127 APS Mode
[0: Not forbidden / 1: Forbidden]
001 Sets APS forbidden or not.
APS means "Auto paper size selection".
Fax Printing Mode at Optional Counter Off
5167
Enables or disables the automatic print out without an accounting device. This SP is used
when the receiving fax is accounted by an external accounting device.
001
CE Login
5169
If you change the printer bit switches, you must 'log in' to service mode with this SP before
you go into the printer SP mode.
001 CE Login
[0=Yes / 1=Standby only / 2=No]
[0 = Feed In / 1 = Exit]
[ 0 or 1 / 0 / – ]
CTL 0: Automatic printing
1: No automatic printing
[0 or 1 / 0 / - ]
CTL 0: Disabled
1: Enabled
System Service Mode
57